DMP Electronics Security Command 690 Manuale Utente Scaricare il pdf (Pagina 6)

CLOSING CHECK/EXTEND

Opening and Closing Schedules may be utilized to check to see

if the burglary system is armed by a scheduled time each day. The

closing check feature will verify that all areas of the system are

armed when the permanent and temporary schedule expires. If an

area is not armed the keypad will display CLOSING TIME.* The

steady trouble tone will also sound. If the system is not armed or a

schedule extended within ten minutes, a no closing report will be

transmitted to the central station receiver.

The closing schedule can be lengthened by entering a temporary

schedule or using the extend feature. The extend function step by

step follows. Temporary schedules are described in the schedule

menu option section.

If an area has been disarmed outside of any permanent or tempo-

rary schedule, the closing check sequence will occur one hour after

the area was disarmed.

Extending A Schedule is accomplished by pressing a top row key

to silence the closing time display. After a valid code number is

accepted the keypad will request the new closing time. Any time

may be entered up to 11:59 p.m. If no time is entered the closing

time will be extended for one hour.

Step by Step:

1. When a schedule expires CLOSING TIME! *

will be displayed and the steady trouble

tone will sound.

2. Press any top row key to silence the tone. The display will read

ENTER CODE:- .

3. Enter at least a level six code number and press

The display will read - : AM PM .

AM PM

4. Enter the new closing time and press the or

key.

5. If no time is entered in step 4, the schedule will be extended for

one hour

* If the system has been programmed to provide independent

schedules per

area, the closing time will be replaced by AREA NAME-LATE

COMMAND

FIRE RESET

detectors are automatically reset. Insure that all smoke is cleared

from the detector before resetting.

Step By Step:

1. Press the key until FIRE RESET? is

displayed.

2. When FIRE RESET? is displayed press any one of

the top four

select keys. The display will read ENTER CODE:- .

User Code Level: 1- During permanent or temporary

schedules only

3- Anytime

Function: Resets smoke detectors

Fire Reset is used to reset smoke detectors after they have been

tripped. Once a smoke detector has been tripped it must be reset

before it will function again. When Fire Reset is selected the smoke

COMMAND

1 2 3 4 5 6 7 8 9 10 11 ... 16 17

Commenti su questo manuale

Nessun commento

DMP Electronics Security Command 690 Manuale Utente Pagina 6

Commenti su questo manuale

Prodotti e manuali riguardandi Tastierini numerici DMP Electronics Security Command 690